Build standards and specifications suitable for China's IT service operation with SPS as the core


Time:

2023-03-30

Snowflakes are white and sticky. Cause: the humidity of the stickers is too high. Solution: Because pasting paper is made of white latex, and the water content of white latex is high, so after the sticker, the resin coating can be carried out after a long time.

1, Snow White sticky hands

Formation reason: sticker humidity is too high.

Solution: Because pasting paper is made of white latex, and the water content of white latex is high, so after the sticker, the resin coating can be carried out after a long time.

Cause: The operating environment temperature is too low

Solution: Some heating measures can be used to raise the ambient temperature

Formation reason: the humidity of the air is too high.

Solution: The board should not be placed for too long after drying, easy to return to damp, should be used as soon as possible.

Formation reason: improper selection of accelerator, curing agent or its poor quality.

Solution: The general use of 5%, 6% concentration of cobalt water and high quality, small water content of curing agent. The gelling time is generally controlled in 4 ~ 6 minutes, and the amount of curing agent is generally 2.5 ~ 3 in the amount of cobalt water.

2. The resin layer is too brittle

Cause of formation: excessive dosage of accelerators and curing agents

Solution: reduce the amount of accelerator curing agent, the gelling time is generally controlled in 4 ~ 6 minutes, the curing agent amount is generally 2.5 ~ 3 in the amount of cobalt water

3. The resin layer is too soft

Formation reason: accelerant, curing agent dosage is too little

Solution: Increase the amount of accelerator curing agent, the gelling time is generally controlled in 4 ~ 6 minutes, the curing agent amount is generally 2.5 ~ 3 in the amount of cobalt water

4, the surface brightness is poor, fullness is poor

Formation reason: the effect of film type

Solution: There are many kinds of film, which must be selected according to their own requirements.

Formation reason: coating thickness influence

Solution: The fullness of general thick coating is better than thin coating.

Formation reason: the selection of resin viscosity influence.

Solution: The thickness of the film formed by the resin with high viscosity is better.