gtag('config', 'AW-17157616935');
新闻资讯

Company announcement

Industry information

Common problems and treatment methods of FRP production

Common problems and treatment methods of FRP production

Gelcoat wrinkle skin, the formation of the cause: gelcoat curing insufficient to carry out the next step of work, solution: according to the environmental temperature and humidity, adjust the formula, fully solidified after the construction

13

2023

/

03

Sanitary ware resin use common problems and solutions

Sanitary ware resin use common problems and solutions

Cylinder problem, formation reason: acrylic plate is too thin. After the formation of the diamond horn thin, can not withstand the resin curing temperature, resulting in the plate becomes soft wrinkle, burn out. Solution: Increase the thickness of acrylic plate or first in the thin diamond corner position on a layer of resin to thicken, play the role of protective layer, this layer of resin curing (still in the sticky state) and then paste on the surface of glass steel.

13

2023

/

03

Craft production common problems and solutions

Craft production common problems and solutions

Water lines, sticky hands, forming reasons: poor mold texture, mold is not dry enough. Solution: Use good silicone mold and keep the mold clean and dry.

13

2023

/

03

Unsaturated polyester resin industry introduction

Unsaturated polyester resin industry introduction

Suitable for the production of translucent, grille plate, pultrusion pipeline and other pultrusion molding products; Product features: good operability and processing properties after the section, for the phthalic unsaturated polyester resin, with medium viscosity and high reactivity, glass fiber wettable, high strength, good surface gloss.

28

2022

/

07

Unsaturated polyester resin safety technical specification

Unsaturated polyester resin safety technical specification

Part I Chemical and enterprise logo. Chinese name of chemical: UNSATURATED POLYESTER resin, English name of chemical: POLYESTER RESINS, manufacturer name: Huizhou Goodell Synthetic Materials Co., LTD

12

2021

/

11

SMC common problems and solutions

SMC common problems and solutions

Sticky film formation reason: mold surface finish is not good solution: increase the mold finish reason: material shrinkage rate is too large or too small solution: improve the shrinkage performance of the material

12

2021

/

11

< 1234 >