Soft resin use common problems and solutions


Time:

2021-11-09

Product too strong or too brittle cause: curing too fast solution: reduce the proportion of curing agent, accelerator

1, the product is too strong or too crisp

Formation reason: curing too fast

Solution: reduce the proportion of curing agent and accelerator

2. Products are too soft and sticky

Formation reason: curing too slow

Solution: increase the proportion of curing agent and accelerator

3. Burst after assembly

Formation reason: powder added too much or uneven mixing.

Solution: reduce the proportion of stone powder, stir thoroughly

Cause of formation: The bubbles do not drain clean

Solution: increase the time of evacuation or extend the gelation time

Formation reason: curing too fast

Solution: Adjust the proportion of curing agent and accelerator