1、Snowflakes white and sticky
Formation reasons：Too much humidity in the sticker.
Solution：Because the paste paper uses white latex，white latex has a higher water content，Therefore, resin coating can only be carried out after stickers are placed for a long time.
Formation reasons：The ambient temperature is too low.
Solution：Some heating measures can be used to raise the ambient temperature.
Formation reasons：The air humidity is too high.
Solution：Paste board after drying should not be placed too long, easy to return to moisture, should be used as soon as possible.
Formation reasons：Accelerant, curing agent variety selection is improper or its quality is poor.
Solution：Generally use 5%, 6% concentration of cobalt water and high quality, small water content of curing agent.The gelation time is generally controlled in 4 ~ 6 minutes, and the amount of curing agent is generally 2.5 ~ 3 in the amount of cobalt water.
2、The resin layer too brittle
Formation reasons：Excessive dosage of accelerant and curing agent
Solution：Reduce the amount of accelerator curing agent, the gelling time is generally controlled in 4 ~ 6 minutes, the amount of curing agent is generally 2.5 ~ 3times in the amount of cobalt water
3、The resin layer too soft
Formation reasons：The amount of accelerant and curing agent is too small.
Solution：Increase the amount of accelerator curing agent, the gelling time is generally controlled in 4 ~ 6 minutes, the amount of curing agent is generally 2.5 ~ 3times in the amount of cobalt water
4、Surface brightness bad、Fullness bad
Formation reasons：Influence of film type
Solution：There are many kinds of film, so you must choose according to your own requirements.
Formation reasons:Coating thickness effect
Solution：The fullness of a thick coat is generally better than that of a thin coat.
Formation reasons：Selection of resin viscosity effect.
Solution：The fullness of the paint film formed by the resin with high viscosity is better.